5-65
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
NTP-G99 Modify Line Settings and PM Parameter Thresholds for MXP_MR_2.5G and MXPP_MR_2.5G Cards
NTP-G99 Modify Line Settings and PM Parameter Thresholds for
MXP_MR_2.5G and MXPP_MR_2.5G Cards
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to change the
muxponder card settings. If you are already logged in, proceed to Step 2.
Step 2 As needed, complete the “NTP-G103 Back Up the Database” procedure on page 13-2 to preserve the
existing transmission settings.
Step 3 Perform any of the following tasks as needed:
• DLP-G235 Change Card Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards, page 5-66
• DLP-G236 Change Client Line Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards, page
5-67
• DLP-G237 Change Distance Extension Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards,
page 5-69
• DLP-G238 Change OC-48/STM-16 Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards, page
5-71
• DLP-G239 Change Section Trace Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards, page
5-73
• DLP-G240 Change MXP_MR_2.5G and MXPP_MR_2.5G Card Line Threshold Settings for
SONET or SDH Payloads, page 5-74
• DLP-G321 Change the MXP_MR_2.5G or MXPP_MR_2.5G Card Line Thresholds for 1G Ethernet
or 1G FC/FICON Payloads, page 5-77
• DLP-G307 Provision the MXP_MR_2.5G and MXPP_MR_2.5G Trunk Port Alarm and TCA
Thresholds, page 5-79
• DLP-G308 Provision the MXP_MR_2.5G and MXPP_MR_2.5G Client Port Alarm and TCA
Thresholds, page 5-80
Note To use the Alarm Profiles tab, including creating alarm profiles and suppressing alarms, see
Chapter 8, “Manage Alarms.”
Purpose This procedure changes the line and threshold settings for MXP_MR_2.5G
and MXPP_MR_2.5G muxponder cards.
Tools/Equipment None
Prerequisite Procedures NTP-G32 Install the Transponder and Muxponder Cards, page 3-43
DLP-G63 Install an SFP or XFP, page 3-45
DLP-G277 Provision a Multirate PPM, page 5-3 (if necessary)
DLP-G278 Provision the Optical Line Rate, page 5-6 (if necessary)
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
