Cisco ONS 15454 DWDM - DLP- G54 Create a New User on a Single Node

3-6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
DLP-G54 Create a New User on a Single Node
DLP-G54 Create a New User on a Single Node
Step 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 In the Users window, click Create.
Step 3 In the Create User dialog box, enter the following:
• Name—Type the user name. The name must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) characters. For TL1 compatibility, the user name must be 6 to
10 characters.
• Password—Type the user password. The password must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) and special (+, #,%) characters, where at least two characters are
non alphabetic and at least one character is a special character. For TL1 compatibility, the password
must be 6 to 10 characters.
Note The password must not contain the user name.
• Confirm Password—Type the password again to confirm it.
• Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. See the “20.1 User IDs and Security Levels” section on
page 20-1 for information about the capabilities provided with each level.
Note Each security level has a different idle time. The idle time is the length of time that CTC can
remain idle before the password must be reentered. The defaults are: Retrieve user = unlimited,
Maintenance user = 60 minutes, Provisioning user = 30 minutes, and Superuser = 15 minutes.
To change the idle times, see the “NTP-G88 Modify Users and Change Security” procedure on
page 10-45.
Step 4 Click OK.
Step 5 Return to your originating procedure (NTP).
Purpose This task creates a new user for one ONS 15454.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser