9-6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G135 Reset Current PM Counts
Step 9 Return to your originating procedure (NTP).
DLP-G135 Reset Current PM Counts
Step 1 In node view (single-shelf mode), or shelf view (multishelf mode), double-click the DWDM, TXP, or
MXP card where you want to reset the current PM counts. The card view appears.
Step 2 Click the Performance tab.
Step 3 If you want to reset the PM counts for a subtab, click the relevant subtab(s), located along the left side
of the Performance tab.
Note Performance subtabs vary, depending on the card viewed.
Step 4 If you want to reset the PM counts for a specific port, select the port from the Ports drop-down list (where
available).
Note You cannot change the PM count interval on the TXP or MXP card Optics PM > Current Values
tab.
Step 5 Click Baseline.
Note The Baseline button clears the PM counts displayed in the current time interval but does not clear
the PM counts on the card. When the current time interval expires or the window view changes,
the total number of PM counts on the card and in the window appears in the appropriate column.
The baseline values are discarded if you change views to a different window and then return to
the Performance window.
Step 6 View the current statistics columns to observe changes to PM counts for the current time interval.
Step 7 Return to your originating procedure (NTP).
Purpose This task clears the current PM count, but it does not clear the
cumulative PM count. This task allows you to see how quickly PM
counts rise.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
