5-68
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G236 Change Client Line Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
ALS Mode Sets the ALS function mode. The DWDM
transmitter supports ALS according to
ITU-T G.644 (06/99). ALS can be disabled or can
be set for one of three mode options.
• Disable (default): ALS is off; the laser is not
automatically shut down when traffic outages
(LOS) occur.
• Auto Restart: ALS is on; the laser automatically
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
• Manual Restart: ALS is on; the laser automatically
shuts down when traffic outages (LOS) occur.
However, the laser must be manually restarted
when conditions that caused the outage are
resolved.
• Manual Restart for Test: Manually restarts the
laser for testing.
Reach Displays the optical reach distance of the client
port.
The Reach options depend on the traffic type that has
been selected.
Wavelength Displays the wavelength of the client port.
• First Tunable Wavelength
• Further wavelengths: 1310 nm to 1550 nm
100-GHz ITU spacing
CWDM spacing
• Supported wavelengths are marked by asterisks
(**)
Table 5-42 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Client Service Tab Settings (continued)
Parameter Description Options
To Next Page
Loading...
