1-7
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
DLP-G2 Inspect the Shelf Assembly
Note The fan-tray assembly is shipped separately.
Step 5 Return to your originating procedure (NTP).
DLP-G2 Inspect the Shelf Assembly
Step 1 Open the shelf using the pinned hex key. For more information, see the “DLP-G9 Open the Front Cabinet
Compartment (Door)” task on page 1-20.
Step 2 Verify the following:
• The pins are not bent or broken.
• The frame is not bent.
Step 3 If the pins are bent or broken, or the frame is bent, call your Cisco sales engineer for a replacement.
Step 4 Close the front door before installing.
Step 5 Return to your originating procedure (NTP).
Purpose This task verifies that all parts of the shelf assembly are in good condition.
Tools/Equipment Pinned hex (Allen) key for front door
Prerequisite Procedures DLP-G1 Unpack and Verify the Shelf Assembly, page 1-6
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
