Cisco ONS 15454 DWDM - DLP- G141 View Optical Power Statistics for 32 MUX-O, 32-WSS, 32-DMX-O, and 32 DMX Cards

9-13
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G141 View Optical Power Statistics for 32MUX-O, 32-WSS, 32-DMX-O, and 32DMX Cards
– 4—DC TX
• For the OPT-BST card, the following ports are available to view:
– 1—COM RX
– 2—COM TX
– 3—OSC RX
– 4—OSC TX
– 5—Line RX
Step 4 Click Refresh. Optical power statistics for the selected port appear.
Step 5 Click the Opt. Ampli. Line tab.
Step 6 Click Refresh. Optical power statistics for the optical amplifier output port (COM TX, Port 02 for the
OPT-PRE card, and Line TX, Port 06 for the OPT-BST card) appear.
Step 7 Return to your originating procedure (NTP).
DLP-G141 View Optical Power Statistics for 32MUX-O, 32-WSS, 32-DMX-O, and
32DMX Cards
Step 1 In node view, double-click the 32MUX-O, 32WSS, 32-DMX-O, or 32DMX card where you want to view
PM counts. The card view appears.
Step 2 Click the Performance > Optical Chn tabs (Figure 9-3 on page 9-14).
Purpose This task enables you to view optical power statistics for a 32MUX-O,
32WSS, 32-DMX-O, or 32DMX card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher