EasyManua.ls Logo

Cisco ONS 15454 DWDM - DLP- G225 Change Trunk Settings for MXP_2.5 G_10 G and MXP_2.5 G_10 E Cards

Cisco ONS 15454 DWDM
1218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-38
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G225 Change Trunk Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
DLP-G225 Change Trunk Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 1 In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
section trace settings.
Step 2 Click the Provisioning > Line > Trunk tab.
Step 3 Modify any of the settings described in Table 5-19.
Purpose This task provisions the trunk settings for MXP_2.5G_10G and
MXP_2.5G_10E muxponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-19 MXP_2.5G_10G and MXP_2.5G_10E Muxponder Card Trunk Settings
Parameter Description Options
Port # (Display only) Displays the port number. Port 5 is
the DWDM trunk (OC-192/STM-64) that provides
wavelength services.
5
Port Name Provides the ability to assign the specified port a
logical name.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the “DLP-G104 Assign a Name to a Port” task
on page 7-10.
Admin State Sets the port service state unless network conditions
prevent the change. For more information about
administrative states, see Appendix C, “DWDM
Administrative and Service States.”
IS (ANSI) or Unlocked (ETSI)
IS,AINS (ANSI) or
Unlocked,automaticInService (ETSI)
OOS,DSBLD (ANSI) or Locked,disabled
(ETSI)
OOS,MT (ANSI) or Locked,maintenance
(ETSI)
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service states
appear in the format: Primary State-Primary State
Qualifier, Secondary State. For more information
about service states, see Appendix C, “DWDM
Administrative and Service States.”
IS-NR (ANSI) or Unlocked-enabled (ETSI)
OOS-AU,AINS (ANSI) or Unlocked-disabled,
automaticInService (ETSI)
OOS-MA,DSBLD (ANSI) or
Locked-enabled,disabled (ETSI)
OOS-MA,MT (ANSI) or
Locked-enabled,maintenance (ETSI)

Table of Contents

Other manuals for Cisco ONS 15454 DWDM

Related product manuals