11-23
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
NTP-G92 Modify 32MUX-O, 32DMX-O, 32DMX, and 4MD Line Settings and PM Thresholds
Step 4 Click Apply. If the change affects traffic, a warning message displays. Click Yes to complete the
change.
Step 5 Return to your originating procedure (NTP).
NTP-G92 Modify 32MUX-O, 32DMX-O, 32DMX, and 4MD Line
Settings and PM Thresholds
Note Complete the “DLP-G141 View Optical Power Statistics for 32MUX-O, 32-WSS, 32-DMX-O, and
32DMX Cards” task on page 9-13 to view multiplexer and demultiplexer optical power statistics.
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to change the
32MUX-O, 32DMX-O, 32DMX, or 4MD-xx.x card settings. If you are already logged in, proceed to
Step 2.
Step 2 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Step 3 Perform any of the following tasks as needed:
• DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards, page 11-24
• DLP-G209 Change Optical Line Threshold Settings for Multiplexer and Demultiplexer Cards, page
11-26
• DLP-G210 Change Optical Channel Settings for Multiplexer and Demultiplexer Cards, page 11-27
• DLP-G211 Change Optical Channel Threshold Settings for Multiplexer and Demultiplexer Cards,
page 11-30
Step 4 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Stop. You have completed this procedure.
Purpose This procedure changes the line and PM parameter threshold settings for
the multiplexer and demultiplexer cards. The cards included in this
category are the 32MUX-O, 32DMX-O, 32DMX, and 4MD-xx.x cards.
Tools/Equipment None
Prerequisite Procedures NTP-G30 Install the DWDM Cards, page 3-39
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
