Cisco ONS 15454 DWDM - NTP- G20 Set up a Remote Access Connection to the ONS 15454

2-23
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 2 Connect the PC and Log into the GUI
NTP-G20 Set Up a Remote Access Connection to the ONS 15454
Step 4 On the right side of the Preferences dialog box under Proxies, perform one of the following options:
• Choose Direct connection to the Internet to bypass the proxy server.
• Choose Manual proxy configuration to add exceptions to the proxy server, then click View. In the
Manual Proxy Configuration dialog box under Exceptions, enter the IP addresses of the ONS 15454
nodes that you will access. Separate each address with a comma. Click OK to close each open dialog
box.
Step 5 Return to your originating procedure (NTP).
NTP-G20 Set Up a Remote Access Connection to the ONS 15454
Step 1 Connect the modem to the RJ-45 (LAN) port on the TCC2/TCC2P card, to the LAN pins on the
ONS 15454 backplane (ANSI only), or to the RJ-45 jack on the MIC-C/T/P FMEC (ETSI only).
Step 2 While referring to the modem documentation, complete the following tasks to provision the modem for
the ONS 15454:
• For CTC access, set the modem for Ethernet access.
• Assign an IP address to the modem that is on the same subnet as the ONS 15454.
• The IP address the modem assigns to the CTC computer must be on the same subnet as the modem
and the ONS 15454.
Note For assistance on provisioning specific modems, contact the Cisco Technical Assistance Center
(Cisco TAC). See the “Obtaining Technical Assistance” section on page lxxvi as needed.
Step 3 Continue with the “NTP-G21 Log into the ONS 15454 GUI” procedure on page 2-24.
Stop. You have completed this procedure.
Purpose This procedure connects the CTC computer to an ONS 15454 using a LAN
modem. To complete this procedure:
• A modem must be connected to the ONS 15454.
• The modem must be provisioned for ONS 15454. To run CTC, the
modem must be provisioned for Ethernet access.
Tools/Equipment Modem and modem documentation
Prerequisite Procedures NTP-G17 Set Up Computer for CTC, page 2-2
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None