13-3
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
NTP-G104 Restore the Database
NTP-G104 Restore the Database
Note The following parameters are not backed up and restored: node name, IP address, subnet mask and
gateway, and IIOP port. If you change the node name and then restore a backed up database with a
different node name, the circuits map to the new renamed node. Cisco recommends keeping a record of
the old and new node names.
Caution If you are restoring the database on multiple nodes, wait approximately one minute after the
TCC2/TCC2P card reboot has completed on each node before proceeding to the next node.
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you are restoring the
database. If you are already logged in, continue with Step 2.
Step 2 Click the Circuits tab. Verify that no optical channel network connection (OCHNC) circuits have a
PARTIAL_OOS state. If so, investigate and resolve the partial state before continuing.
Step 3 Complete the “DLP-G157 Disable Automatic Power Control” task on page 10-4.
Step 4 In node view, click the Maintenance > Database tabs.
Step 5 Click Restore.
Step 6 Locate the database file stored on the workstation hard drive or on network storage.
To clear all existing provisioning, locate and upload the database found on the latest ONS 15454
software CD.
Step 7 Click the database file to highlight it.
Step 8 Click OK. The DB Restore dialog box appears. Opening a restore file from another node or from an
earlier backup might affect traffic on the login node.
Step 9 Click Yes .
The Restore Database dialog box monitors the file transfer (Figure 13-1).
Figure 13-1 Restoring the Database—In-Process Notification
Step 10
Wait for the file to complete the transfer to the TCC2/TCC2P card.
Purpose This procedure restores the TCC2/TCC2P card software database.
Tools/Equipment None
Prerequisite Procedures NTP-G103 Back Up the Database, page 13-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
