7-22
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 7 Create Channels and Circuits
DLP-G112 Delete Overhead Circuits
• Old IP Address—Type the node’s original IP address.
Step 6 Click Next.
Step 7 Click Finish.
Step 8 Return to your originating procedure (NTP).
DLP-G112 Delete Overhead Circuits
Caution Deleting overhead circuits is service affecting if the circuits are in service (IS). To put circuits out of
service (OOS), see the “DLP-G108 Change the Service State for a Port” task on page 7-18.
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > Overhead Circuits tabs.
Step 3 Click the overhead circuit that you want to delete: local or express orderwire, user data, IP-encapsulated
tunnel, or DCC tunnel.
Step 4 Click Delete.
Step 5 In the confirmation dialog box, click Ye s to continue.
Step 6 Return to your originating procedure (NTP).
Purpose This task deletes overhead circuits. Overhead circuits include
IP-encapsulated tunnels, AIC and AIC-I card orderwire, and UDCs.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
