Cisco ONS 15454 DWDM - DLP- G38 Run the CTC Installation Wizard for UNIX

2-6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 2 Connect the PC and Log into the GUI
DLP-G38 Run the CTC Installation Wizard for UNIX
Step 13 Click Finish.
Step 14 Return to your originating procedure (NTP).
DLP-G38 Run the CTC Installation Wizard for UNIX
Note If you will log into nodes running CTC software earlier than Software R4.6, uninstall JRE 1.4.2 and
reinstall JRE 1.3.1_2. To run Software R4.7, R5.0, or R6.0, uninstall JRE 1.3.1_2 and reinstall JRE
1.4.2.
Note JRE 1.4.2 requires Netscape 7.x or Internet Explorer 6.x.
Step 1 Verify that your computer has the following:
• RAM—384 MB recommended, 512 MB optimum
• Hard drive—20 GB hard drive recommended with at least 50 MB of space available
• Operating system—Solaris 8 or 9
Note These requirements are guidelines. CTC performance is faster if your computer has a faster
processor and more RAM.
Step 2 Change the directory. Type:
cd /cdrom/cdrom0/
Step 3 From the techdoc454 CD directory, type:
./setup.bat
The Cisco Transport Controller Installation Wizard displays the components that will be installed on
your computer:
• Java Runtime Environment 1.4.2
• Acrobat Reader 6.0.1
Purpose This task installs the CTC online user manuals, Acrobat 6.0.1, and
JRE 1.4.2 on UNIX workstations, as necessary. JRE 1.4.2 is required to
run Release 6.0.
Tools/Equipment Cisco ONS 15454 Release 6.0 software CD
Prerequisite Procedures None
Required/As Needed This task is required if you will use a UNIX workstation to run CTC and
any of the following are true:
• JRE 1.4.2 is not installed.
• CTC online user manuals are not installed and are needed.
Onsite/Remote Onsite or remote
Security Level None