5-33
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G222 Change Card Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
Table 5-16 MXP_2.5G_10G or MXP_2.5G_10E Muxponder Card Settings
Parameter Description Options
Termination
Mode
Sets the mode of operation. Options that
do not apply to a card do not display.
The MXP_2.5G_10G card is based on
SONET/SDH multiplexing. The
transparent mode terminates and rebuilds
the B1 byte (as well as other bytes) of the
incoming OC-48/STM-16 signal. The B2
byte is not touched.
The MXP_2.5G_10E card is fully
transparent in transparent mode based on
the OTN/ITU-T G.709 multiplexing
scheme. It does not terminate the B1 byte
or other bytes.
It encapsulates OC-48/STM-16 bytes into
ODU1 first, then multiplexes them into an
OTU2.
See the “16.12 Termination Modes”
section on page 16-117 for more
information.
For ANSI platforms:
• Transparent
• Section (MXP_2.5G_10E only)
• Line (MXP_2.5G_10E only)
For ETSI platforms:
• Transparent
• Multiplex Section (MXP_2.5G_10E
only)
• Regeneration Section
(MXP_2.5G_10E only)
Wavelength Sets the wavelength of the DWDM side
optical transmitter. You can set the
wavelength to the First Tunable
Wavelength or to further wavelengths in
100 GHz ITU spacing.
• First Tunable Wavelength
• Further wavelengths in 100-GHz ITU
grid specification
• Supported wavelengths are in white
and marked by asterisks (**);
unsupported wavelengths are gray
Note The four available wavelengths
are listed in the Card Parameters
section of the window and also in
the Maintenance > Info tab.
AIS/Squelch (MXP_2.5G_10E only) Sets the
transparent termination mode
configuration.
• Ais
• Squelch
Card
Parameters
Displays the settings for the card. Display only
To Next Page
Loading...
