Cisco ONS 15454 DWDM - Utilization Tab on the Card View Performance Window

9-29
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G150 View Payload Utilization PM Parameters
Figure 9-11 Utilization Tab on the Card View Performance Window
Step 3
Click Refresh. PM utilization values appear for each port on the card.
Step 4 View the appropriate row for the port you want to monitor.
Step 5 The transmit (Tx) and receive (Rx) bandwidth utilization values for the previous time intervals appear
in the Prev-n columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in
the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting Guide.
Note To refresh, reset, or clear PM counts, see the “NTP-G73 Change the PM Display” procedure on
page 9-2.
Step 6 Return to your originating procedure (NTP).
115776
Payload PM tab
Performance tab
Card View
Utilization tab
Refresh
button
Help
button
Interval
menu