1-63
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
NTP-G12 Install and Close the FMEC Cover (ETSI Only)
NTP-G12 Install and Close the FMEC Cover (ETSI Only)
Step 1 Insert the cover carefully onto the left pin of the hinge (Figure 1-26).
Step 2 Move the cover to the right side towards the right pin of the hinge.
Step 3 Pull the right side of the hinge-locking spring (Figure 1-26). Push the cover onto the right pin until the
spring snaps into place.
Figure 1-26 ONS 15454 ETSI FMEC Cover
Step 4
Attach the ground wire to the shelf.
Step 5 Attach the washer and nut.
Step 6 Attach the cover to the shelf using the screws on the top of the cover.
Purpose This procedure installs and closes the ONS 15454 ETSI FMEC cover.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Prerequisite Procedures NTP-G4 Open and Remove the FMEC Cover (ETSI Only), page 1-23
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
71087
F
A
N
F
A
IL
C
R
IT
M
A
J
M
IN
Pin hinge
FMEC cover
Hinge-locking
spring
To Next Page
Loading...
