5-48
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
NTP-G98 Modify Line Settings and PM Parameter Thresholds for TXP_MR_2.5G and TXPP_MR_2.5G Cards
NTP-G98 Modify Line Settings and PM Parameter Thresholds for
TXP_MR_2.5G and TXPP_MR_2.5G Cards
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to change the
transponder card settings. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the “NTP-G103 Back Up the Database” procedure on page 13-2 to preserve the
existing transmission settings.
Step 3 Perform any of the following tasks as needed:
• DLP-G229 Change Card Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards, page 5-49
• DLP-G230 Change Line Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards, page 5-50
• DLP-G231 Change Section Trace Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards, page
5-53
• DLP-G232 Change TXP_MR_2.5G and TXPP_MR_2.5G Cards Line Threshold Settings for
SONET or SDH Payloads, page 5-54
• DLP-G320 Change the TXP_MR_2.5G or TXPP_MR_2.5G Card Line Thresholds for 1G Ethernet
or 1G FC/FICON Payloads, page 5-56
• DLP-G305 Provision the TXP_MR_2.5G and TXPP_MR_2.5G Trunk Port Alarm and TCA
Thresholds, page 5-57
• DLP-G306 Provision the TXP_MR_2.5G and TXPP_MR_2.5G Cards Client Port Alarm and TCA
Thresholds, page 5-58
• DLP-G234 Change OTN Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards, page 5-62
Stop. You have completed this procedure.
Purpose This procedure changes the line and threshold settings for TXP_MR_2.5G
and TXPP_MR_2.5G transponder cards.
Tools/Equipment None
Prerequisite Procedures NTP-G32 Install the Transponder and Muxponder Cards, page 3-43
DLP-G63 Install an SFP or XFP, page 3-45
DLP-G277 Provision a Multirate PPM, page 5-3 (if necessary)
DLP-G278 Provision the Optical Line Rate, page 5-6 (if necessary)
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
