8-25
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 8 Manage Alarms
NTP-G69 Enable, Modify, or Disable Alarm Severity Filtering
NTP-G69 Enable, Modify, or Disable Alarm Severity Filtering
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to enable alarm
severity filtering. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the “DLP-G126 Enable Alarm Filtering” task on page 8-25. This task enables
alarm filtering at the card, node, and network views for all nodes in the network. Alarm filtering can be
enabled for alarms, conditions, or events.
Step 3 As needed, complete the “DLP-G127 Modify Alarm, Condition, and History Filtering Parameters” task
on page 8-26 to modify the alarm filtering for network nodes to show or hide particular alarms or
conditions.
Step 4 As needed, complete the “DLP-G128 Disable Alarm Filtering” task on page 8-28 to disable alarm profile
filtering for all network nodes.
Stop. You have completed this procedure.
DLP-G126 Enable Alarm Filtering
Step 1 At node, network, or card view, click the Alarms tab.
Step 2 Click the Filter tool icon on the right side of the bottom toolbar.
Note The Filter tool icon differs from the Filter button at the bottom left of the screen.
Alarm filtering is enabled if the tool is selected and disabled if the tool is raised (not selected).
Purpose Use this procedure to start, change, or stop alarm filtering for one or more
severities in the Alarms, Conditions, and History windows in all network
nodes.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This task enables alarm filtering for alarms, conditions, or event history in
all network nodes.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote
Onsite or remote
Security Level
Retrieve or higher
To Next Page
Loading...
