5-8
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G279 Change the Optical Line Rate
DLP-G279 Change the Optical Line Rate
Step 1 In node view, double-click the TXP or MXP card where you want to edit the PPM port rate.
Step 2 Click the Provisioning > Pluggable Port Modules tabs.
Step 3 Click the port with the port rate you that want to change in the Pluggable Ports area. The highlight
changes to dark blue.
Step 4 Click Edit. The Edit Port Rate dialog box appears.
Step 5 In the Change To field, use the drop-down list to select the new port rate and click OK. Table 5-1 on
page 5-7 lists the available rates.
Step 6 Click Yes in the Confirm Port Rate Change dialog box.
Step 7 Return to your originating procedure (NTP).
DLP-G280 Delete a PPM
Note This task does not apply to the TXP_MR_10G card.
Step 1 In node view, double-click the TXP or MXP card where you want to delete PPM settings.
Step 2 Click the Provisioning > Pluggable Port Modules tabs.
Purpose This task edits PPM port rates for the TXP and MXP cards. Perform this
task if you want to change the port rate on a multirate PPM that is already
provisioned.
Tools/Equipment None
Prerequisite Procedures DLP-G277 Provision a Multirate PPM, page 5-3
DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task deletes PPM provisioning for SFPs or XFPs installed on TXP or
MXP cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
DLP-G63 Install an SFP or XFP, page 3-45 or
DLP-G273 Preprovision an SFP or XFP Slot, page 3-46
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
