13-9
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
NTP-G133 View and Manage OSI Information
NTP-G133 View and Manage OSI Information
Note Additional information about the ONS 15454 implementation of OSI is provided in the Management
Connectivity Reference chapter.
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25. If you are already logged in, continue with
Step 2.
Step 2 Perform any of the following tasks as needed:
• DLP-G298 View IS-IS Routing Information Base, page 13-9
• DLP-G299 View ES-IS Routing Information Base, page 13-10
• DLP-G300 Manage the TARP Data Cache, page 13-11
Stop. You have completed this procedure.
DLP-G298 View IS-IS Routing Information Base
Step 1 In node view, click the Maintenance > OSI > IS-IS RIB tabs.
Purpose This procedure allows you to view and manage Open Systems
Interconnection (OSI) including the End System to Intermediate System
(ES-IS) and Intermediate System to Intermediate System (IS-IS) routing
information tables, the Target Identifier Address Resolution Protocol
(TARP) data cache, and the manual area table.
Tools/Equipment None
Prerequisite Procedures NTP-G103 Back Up the Database, page 13-2
NTP-G17 Set Up Computer for CTC, page 2-2
NTP-G132 Provision OSI, page 3-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task allows you to view the IS-IS protocol routing information base
(RIB). IS-IS is an OSI routing protocol that floods the network with
information about NEs on the network. Each NE uses the information to
build a complete and consistent picture of a network topology. The IS-IS
RIB shows the network view from the perspective of the IS node.
Tools/Equipment None
Prerequisite procedures DLP-G46 Log into CTC, page 2-25
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
