3-82
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
DLP-G73 Delete a DWDM Connection
DLP-G73 Delete a DWDM Connection
Step 1 In node view, click the Provisioning > WDM-ANS > Connection tabs.
Step 2 Click the connection you want to delete.
Step 3 Click Delete, then click Yes .
Step 4 Return to your originating procedure (NTP).
NTP-G138 Import a Cisco MetroPlanner Configuration File
Caution Importing the correct Cisco MetroPlanner configuration file is very important. Verify that have the
correct MetroPlanner configuration file for your node before you begin this task. The file will have the
same name as the node name in Cisco MetroPlanner.
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to import the file.
If you are already logged in, continue with Step 2.
Step 2 In CTC node view, click the Provisioning > WDM-ANS > Provisioning tabs.
Step 3 Click Import. The Import NE Update From File dialog box appears.
Step 4 Enter the path to the Assisted Configuration Setup file (see Table 3-1 on page 3-3), or click Browse and
navigate to the configuration file using the Open dialog box.
Step 5 Click OK.
Step 6 Click OK on the import confirmation dialog box.
Purpose This task deletes a DWDM connection.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This task imports the Cisco MetroPlanner Assisted Configuration Setup
file into a node to configure the node automatically.
Tools/Equipment A Cisco MetroPlanner Assisted Configuration Setup file prepared for the
node must be available on a local or network drive
Cisco MetroPlanner Installation Parameters
Prerequisite Procedures NTP-G139 Verify Cisco MetroPlanner Reports and Files, page 3-3
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
