Cisco ONS 15454 DWDM - NTP- G127 Add an AD-XC-XX.X Card to an OADM Node

12-6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 12 Add and Remove Cards and Nodes
NTP-G127 Add an AD-xC-xx.x Card to an OADM Node
Step 9 In the Select Node dialog box, choose the OADM node where you will add the AD-xCxx.x card and click
OK.
Step 10 In the TL1 dialog box, use the DLT-WLEN command to delete the OCHNC cross-connects for the
express path OCHNCs listed in Step 4, as follows:
DLT-WLEN:[<TID>]:<AID>:<CTAG>[:::CMDMDE=<CMDMDE>];
where:
• <AID> is the wavelength AID per ring direction from the wavelength (WLEN) section.
• <CMDMDE> indicates the command execution mode.
For additional information, including valid command values, refer to the Cisco ONS SONET TL1
Command Guide or the Cisco ONS 15454 SDH TL1 Command Guide.
Step 11 Close the TL1 session.
Step 12 In node view, click the Provisioning > WDM-ANS > Connections tabs.
Step 13 Highlight the two express connections that carry the circuits passing through the node. (The express
connections are the only ones connecting an EXP_TX port on the last west-side OADM card, W > E,
with an EXP_RX port on the first east-side OADM card, W > E.)
Step 14 Click Delete.
Step 15 Remove the physical express cables between the EXP_TX and EXP_RX ports specified in Step 13.
Step 16 Insert the new AD-xCxx.x card in the slot identified by your Cisco MetroPlanner site plan.
Step 17 Complete the “NTP-G34 Install Fiber-Optic Cables on DWDM Cards and DCUs” procedure on
page 3-48 for the OADM node, following the new internal connections table generated by Cisco
MetroPlanner.
Step 18 Complete the “NTP-G36 Calculate Cable Connections” procedure on page 3-80.
Step 19 Import the recalculated OADM site parameters. See the “NTP-G138 Import a Cisco MetroPlanner
Configuration File” task on page 3-82.
Step 20 In node view, click the Provisioning > WDM-ANS > Port Status tabs.
Step 21 Click Launch ANS.
Step 22 From the Tools menu, choose Open TL1 Session.
Step 23 In the Select Node dialog box, choose the OADM node and click OK.
Step 24 In the TL1 dialog box, use the ENT-WLEN command to create the OCHNC cross-connects that were
deleted in Step 10, as follows:
ENT-WLEN:[<TID>]:<AID>:<CTAG>:::[SIZE=<SIZE>]:[<PST>],[<SST>];
where:
• <AID> is the wavelength AID.
• <SIZE> is the circuit size allocated on this wavelength.
• <PST> is the primary state.
• <SST> is the secondary state.
For additional information and a list of valid command values, see the Cisco ONS SONET TL1 Command
Guide or the Cisco ONS 15454 SDH TL1 Command Guide.
Step 25 Close the TL1 dialog box.
Step 26 In node view, click the Circuits tab.