5-32
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G222 Change Card Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
DLP-G222 Change Card Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 1 In node view, double-click the MXP_2.5G_10G or and MXP_2.5G_10E card where you want to change
the card settings.
Step 2 Click the Provisioning > Card tabs.
Step 3 Modify any of the settings described in Table 5-16.
Purpose This task changes the card settings for MXP_2.5G_10G or
MXP_2.5G_10E muxponder cards, including payload type, termination
mode, and wavelength.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
