EasyManua.ls Logo

Cisco ONS 15454 DWDM - NTP- G30 Install the DWDM Cards

Cisco ONS 15454 DWDM
1218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-39
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
NTP-G30 Install the DWDM Cards
NTP-G30 Install the DWDM Cards
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Warning
Class I (CDRH) and Class 1M (IEC) laser products.
Statement 1055
Warning
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard.
Statement 1056
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Note Complies with the US Federal Drug Administration Code of Federal Regulations Title 21, Sections
1040.10 and 1040.11, except for deviations pursuant to Laser Notice No. 50, dated July 26, 2001.
Note If protective clips are installed on the backplane connectors of the cards, remove the clips before
installing the cards.
Purpose This procedure describes how to install DWDM cards (OPT-PRE,
OPT-BST, 32MUX-O, 32DMX-O, 32DMX, 32WSS, 4MD-xx.x,
AD-1C-xx.x, AD-2C-xx.x, AD-4C-xx.x, AD-1B-xx.x, AD-4B-xx.x,
OSCM, and OSC-CSM).
Tools/Equipment
Cisco MetroPlanner shelf layout
The following cards, as required by your site plan: OPT-PRE,
OPT-BST, 32MUX-O, 32DMX-O, 32DMX, 32WSS, 4MD-xx.x,
AD-1C-xx.x, AD-2C-xx.x, AD-4C-xx.x, AD-1B-xx.x, AD-4B-xx.x,
OSCM, and OSC-CSM cards (as applicable)
The ONS 15454 NE defaults file if the node will use custom NE
defaults
Prerequisite Procedures NTP-G15 Install the Common Control Cards, page 1-71
NTP-G14 Install DWDM Equipment, page 1-66
NTP-G139 Verify Cisco MetroPlanner Reports and Files, page 3-3
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher

Table of Contents

Other manuals for Cisco ONS 15454 DWDM

Related product manuals