Cisco ONS 15454 DWDM - Figure 3-4 Selecting the Save Configuration Option; Figure 3-5 Saving and Rebooting the TCC2;TCC2 P

3-16
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
DLP-G57 Set the IP Address, Default Router, and Network Mask Using the LCD
Tip The Slot, Status, and Port button positions correspond to the positions of the commands shown
on the LCD. For example, in Figure 3-3, you press the Slot button to invoke the Next command
and the Port button to invoke the Done command.
Step 5 Press the Port button to cycle the IP address or subnet mask to the correct digit.
Step 6 When the change is complete, press the Status button to return to the Node menu.
Step 7 Repeatedly press the Port button until the Save Configuration option appears (Figure 3-4).
Figure 3-4 Selecting the Save Configuration Option
Step 8
Press the Status button to choose the Save Configuration option.
A Save and REBOOT message appears (Figure 3-5).
Figure 3-5 Saving and Rebooting the TCC2/TCC2P
Step 9
Press the Slot button to apply the new IP address configuration or press Port to cancel the configuration.
Saving the new configuration causes the TCC2/TCC2P cards to reboot. During the reboot, a “Saving
Changes - TCC Reset” message displays on the LCD. The LCD returns to the normal alternating display
after the TCC2/TCC2P reboot is complete.
Note The IP address and default router must be on the same subnet. If not, you cannot apply the
configuration.
Step 10 Return to your originating procedure (NTP).
FAN FAIL
Slot
Slot-0
Status=Save Cfg.
44091
CRIT MAJ MIN
Status Port
FAN FAIL
Slot
Save and REBOOT?
<Apply Revert>
44092
CRIT MAJ MIN
Status Port