11-12
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
NTP-G91 Modify OPT-PRE and OPT-BST Line Settings and PM Parameters and Thresholds
NTP-G91 Modify OPT-PRE and OPT-BST Line Settings and PM
Parameters and Thresholds
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to change the
OPT-PRE or OPT-BST amplifier card settings. If you are already logged in, proceed to Step 2.
Step 2 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Step 3 Perform any of the following tasks as needed:
• DLP-G204 Change Optical Line Settings for OPT-PRE and OPT-BST Amplifiers, page 11-12
• DLP-G205 Change Optical Line Threshold Settings for OPT-PRE and OPT-BST Amplifiers, page
11-14
• DLP-G206 Change Optical Amplifier Line Settings for OPT-PRE and OPT-BST Amplifiers, page
11-16
• DLP-G207 Change Optical Channel Threshold Settings for OPT-PRE and OPT-BST Amplifiers,
page 11-18
• DLP-G322 Change the OPT-BST ALS Maintenance Settings, page 11-22
Step 4 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Stop. You have completed this procedure.
DLP-G204 Change Optical Line Settings for OPT-PRE and OPT-BST Amplifiers
Step 1 In node view, double-click the OPT-PRE or OPT-BST amplifier where you want to change the optical
line settings.
Step 2 Click the Provisioning > Optical Line > Parameters tabs.
Purpose This procedure changes the line and threshold settings for the OPT-PRE
and OPT-BST amplifier cards.
Tools/Equipment None
Prerequisite Procedures NTP-G30 Install the DWDM Cards, page 3-39
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the optical line settings for OPT-PRE and OPT-BST
amplifier cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
