Cisco ONS 15454 DWDM - B.4.4 OPT-BST Amplifier Card Specifications

B-15
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
December 2006
Appendix B Hardware Specifications
B.4.4 OPT-BST Amplifier Card Specifications
Maximum gain (standard range with programmable gain tilt): 21 dBm
Maximum gain (extended range with uncontrolled gain tilt): 38.5 dBm
– Gain and power regulation over/undershoot: 0.5 dB
– Limited maximum output power: 17.5 dBm
– Maximum output power (with full channel load): 17 dB
– Minimum output power (with one channel): –1 dBm
– Input power (Pin) range at full channel load: –21.5 to 12 dBm
– Input power (Pin) range at single channel load: –39.5 to –6 dBm
– Noise figure at G
3
21 dB = 6.5 dB
– OSC filter drop (channels) insertion loss maximum: 1 dB
– OSC filter drop (OSC) insertion loss maximum: 1.8 dB
– OSC filter add (OSC) insertion loss maximum: 1.3 dB
– Optical connectors: LC-UPC/2
• Environmental
– Operating temperature:
C-Temp: –5 to +55 degrees Celsius (+23 to +131 degrees Fahrenheit)
– Operating humidity: 5 to 85 percent, noncondensing
• Dimensions
– Height: 12.65 in. (332 mm)
– Width: 0.92 in. (24 mm)
– Depth: 9.00 in. (240 mm)
B.4.4 OPT-BST Amplifier Card Specifications
The OPT-BST amplifier card has the following specifications:
• Optical characteristics:
– Total operating wavelength range: 1530 to 1561.3 nm
– Gain ripple (peak to valley): 1.5 dB
– Gain range: 5 to 20 dBm with programmable gain tilt
– Gain and power regulation over/undershoot: 0.5 dB
– Limited maximum output power: 17.5 dBm
– Maximum output power (with full channel load): 17 dB
– Minimum output power (with one channel): –1 dBm
– Input power (Pin) range at full channel load: –3 to 12 dBm
– Input power (Pin) range at single channel load: –21 to –6 dBm
– Noise figure at G
3
20 dB = 6 dB
– OSC filter drop (channels) insertion loss maximum: 1 dB
– OSC filter drop (OSC) insertion loss maximum: 1.8 dB