Cisco ONS 15454 DWDM - NTP- G23 Create Users and Assign Security

3-5
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
NTP-G23 Create Users and Assign Security
Note If the TCC2/TCC2P cards are not installed, or if their LEDs are not operating as described, do
not continue. Repeat the “DLP-G33 Install the TCC2 or TCC2P Card” task on page 1-72 or refer
to the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting
Guide to resolve installation problems before proceeding to Step 3.
Step 3 If Alarm Interface Controller–International (AIC-I) card is installed, verify that it is installed in Slot 9
and its ACT (active) LED displays a solid green light.
Step 4 Verify that the software release shown on the LCD matches the software release indicated in your site
plan. If the release does not match, perform one of the following procedures:
• Perform a software upgrade using a Cisco ONS 15454 software CD. Refer to the release-specific
software upgrade document.
• Replace the TCC2/TCC2P cards with cards containing the correct release.
Stop. You have completed this procedure.
NTP-G23 Create Users and Assign Security
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you need to create users.
If you are already logged in, continue with Step 2.
Note You must log in as a Superuser to create additional users. The CISCO15 user provided with each
ONS 15454 can be used to set up other ONS 15454 users. You can add up to 500 users to one
ONS 15454.
Step 2 Complete the “DLP-G54 Create a New User on a Single Node” task on page 3-6 or the “DLP-G55 Create
a New User on Multiple Nodes” task on page 3-7 as needed.
Note You must add the same user name and password to each node a user will access.
Step 3 If you want to modify the security policy settings, including password aging and idle user timeout
policies, complete the “NTP-G88 Modify Users and Change Security” procedure on page 10-45.
Stop. You have completed this procedure.
Purpose This procedure creates ONS 15454 users and assigns their security levels.
Tools/Equipment None
Prerequisite Procedures NTP-G22 Verify Common Card Installation, page 3-4
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser