10-36
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G180 Clear a Manual or Force Y-Cable or Splitter Protection Switch
Step 3 In the Selected Group area, click the active card or port.
Step 4 In the Switch Commands drop-down list, click Force.
Step 5 In the Confirm Manual Operation dialog box, click Ye s .
The Force switch will be applied. To clear the Force switch, see the “DLP-G180 Clear a Manual or Force
Y-Cable or Splitter Protection Switch” task on page 10-36.
Step 6 Return to your originating procedure (NTP).
DLP-G180 Clear a Manual or Force Y-Cable or Splitter Protection Switch
Step 1 In node view, click the Maintenance > Protection tabs.
Step 2 In the Protection Groups area, click the protection group that contains the card you want to clear.
Step 3 In the Selected Group area, click the card that you want to clear.
Step 4 In the Switch Commands drop-down list, click Clear.
Step 5 Click Yes in the confirmation dialog box.
The Manual or Force protection switch is cleared.
Step 6 Return to your originating procedure (NTP).
Purpose This task clears a Manual or Force protection switch on a Y-Cable or
splitter protection group.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
DLP-G178 Apply a Manual Y-Cable or Splitter Protection Switch, page
10-35 or
DLP-G179 Apply a Force Y-Cable or Splitter Protection Switch, page
10-35
Required/As Needed As needed
Onsite/Remote Both
Security Level Maintenance or higher
To Next Page
Loading...
