9-16
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G142 View Channel Optical Add/Drop Multiplexer Power Statistics
Step 6 Click the Optical Band tab.
Step 7 In the Port drop-down list, choose the band port (9 or 10 for COM Ports 09 and 10) where you want to
view the power statistics.
Step 8 Click Refresh. The minimum, maximum, and average optical power for the selected band port appear.
Step 9 To change the auto-refresh interval, click Auto Refresh and choose one of the automatic refresh
intervals: None, 15 seconds, 30 seconds, 1 minute, 3 minutes, or 5 minutes.
Step 10 Return to your originating procedure (NTP).
DLP-G142 View Channel Optical Add/Drop Multiplexer Power Statistics
Step 1 In node view, double-click the optical AD-xC-xx.x card where you want to view the optical power
statistics. The card view appears.
Step 2 Click the Performance > Optical Line tabs (Figure 9-5).
Purpose This task enables you to view channel optical add/drop multiplexer
(OADM) minimum, maximum, and average power statistics on an
AD-1C-xx.x, AD-2C-xx.x, or AD-4C-xx.x card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
