9-12
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G140 View Optical Amplifier Power Statistics
DLP-G140 View Optical Amplifier Power Statistics
Step 1 In node view, double-click the optical amplifier card where you want to view PM counts. The card view
appears.
Step 2 Click the Performance > Optical Line tabs (Figure 9-2).
Figure 9-2 Optical Line Tab in the Optical Amplifier Card View Performance Window
Step 3
In the Port drop-down list, choose an optical line port where you want to view the optical power
statistics:
• For the OPT-PRE card, the following ports are available to view:
–
1—COM RX
–
3—DC RX
Purpose This task enables you to view the power statistics on an OPT-PRE or
OPT-BST amplifier card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
96957
Directions
radio buttons
Performance
tab
Optical Line
tab
Card View
Intervals
radio buttons
Clear
button
Help
button
Baseline
button
Auto-refresh
menu
Refresh
button
Signal-type
port menu
To Next Page
Loading...
