9-28
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G150 View Payload Utilization PM Parameters
Note To refresh, reset, or clear PM counts, see the “NTP-G73 Change the PM Display” procedure on
page 9-2.
Step 5 Return to your originating procedure (NTP).
DLP-G150 View Payload Utilization PM Parameters
Step 1 In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to view PM
counts. The card view appears.
Step 2 Click the Performance > Payload PM > Utilization tabs (Figure 9-11).
Purpose This task enables you to view line utilization PM counts on an
MXP_MR_2.5G or MXPP_MR_2.5G card and port to detect possible
performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
