Cisco ONS 15454 DWDM - Figure 1-12 Installing Fmecs on the ONS 15454 ETSI

1-29
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only)
Step 2 Hold the FMEC by the faceplate.
Step 3 Slide the FMEC along the guide rails into the desired FMEC slot or slots.
Step 4 Push the FMEC gently into the connector. The ONS 15454 ETSI FMECs plug into electrical connectors
on the back panel of the shelf assembly when the screws are tightened. Figure 1-12 shows FMEC
installation.
Figure 1-12 Installing FMECs on the ONS 15454 ETSI
Step 5
Tighten the screws.
Step 6 Continue with the “NTP-G7 Install the Power and Ground” procedure on page 1-30.
Stop. You have completed this procedure.
61338
FAN FAIL
CRIT
MAJ
MIN
Mounting screws
Guide rail