5-34
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G223 Change Line Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
DLP-G223 Change Line Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 1 Double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the line settings.
Step 2 Click the Provisioning > Line > SONET (ANSI) or SDH (ETSI) tabs.
Note The SONET tab appears only if you have created a PPM for a given port.
Step 3 Modify any of the settings described in Table 5-17.
Note You must modify Near End, and Far End independently; 15 Min and 1 Day independently; and
Line and Section independently. To do so, choose the appropriate radio button and click Refresh.
Purpose This task changes the line settings for MXP_2.5G_10G or
MXP_2.5G_10E muxponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-17 MXP_2.5G_10G or MXP_2.5G_10E Muxponder Card Line Settings
Parameter Description Options
Port # (Display only) Port number. Ports 1 to 4 are client
ports (OC-48/STM-16). Port 5 (TXP_2.5G_10G) is
the DWDM trunk (OC-192/STM-64) that provides
wavelength services.
• 1
• 2
• 3
• 4
• 5 (MXP_2.5G_10G only)
Port Name Provides the ability to assign the specified port a
logical name.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the “DLP-G104 Assign a Name to a Port” task on
page 7-10.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, “DWDM Administrative and Service
States.”
• IS (ANSI) or Unlocked (ETSI)
• IS,AINS (ANSI) or Unlocked,automaticInService
(ETSI)
• OOS,DSBLD (ANSI) or Locked,disabled (ETSI)
• OOS,MT (ANSI) or Locked,maintenance (ETSI)
To Next Page
Loading...
