3-37
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
NTP-G29 Preprovision a Slot
Step 11 Click Apply.
Stop. You have completed this procedure.
NTP-G29 Preprovision a Slot
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you will preprovision the
slots. If you are already logged in, continue with Step 2.
Step 2 In CTC node view, right-click an empty slot where you will install a card.
Step 3 From the Add Card shortcut menu, choose the card type that will be installed based on the
Cisco MetroPlanner shelf layout (see Table 3-1 on page 3-3). Only cards that can be installed in the slot
appear in the Add Card shortcut menu. The 32WSS, 32-MUX-O, and 32-DMX-O require two vacant
slots, or they will not appear in the menu. Table 3-3 shows the Add Card shortcut menu items, submenu
items, and the card groups and menu options/cards that they reference.
Purpose This procedure preprovisions the ONS 15454 slots in CTC based upon the
Cisco MetroPlanner shelf layout prepared for your site. Preprovisioning the
slots ensures that the physical cards are installed in the slots anticipated by
the parameters contained in the Cisco MetroPlanner Assisted
Configuration Setup that will be imported into CTC.
Tools/Equipment Cisco MetroPlanner shelf layout or JPG file.
Prerequisite Procedures Chapter 2, “Connect the PC and Log into the GUI”
NTP-G139 Verify Cisco MetroPlanner Reports and Files, page 3-3
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 3-3 CTC Add Card Menu for DWDM Cards
Category Option Card
nXP MXPP_MR_10E MXPP_MR_10E
MXP_MR_10E MXP_MR_10E
MXP_MR_10G MXP_MR_10G
MXP_MR_2.5G MXP_MR_2.5G
TXPP_MR_2.5G TXPP_MR_2.5G
TXP_MR_10E TXP_MR_10E
TXP_MR_10G TXP_MR_10G
TXP_MR_2.5G TXP_MR_2.5G
To Next Page
Loading...
