Cisco ONS 15454 DWDM - DLP- G145 Enable or Disable OTN FEC Performance Monitoring

9-21
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G145 Enable or Disable OTN FEC Performance Monitoring
b. DLP-G185 Delete a GCC Termination, page 10-40, if a generic communications channel (GCC) is
provisioned on that port.
Step 3 Click the Provisioning > OTN > OTN Lines tabs.
Step 4 From the G.709 OTN drop-down list, select Enable or Disable to enable or disable ITU-T G.709 for that
port. (Disable is the default).
Step 5 Click Apply.
Step 6 Click the Performance tab to view PM parameters. For PM parameter definitions, refer to the
“Performance Monitoring” chapter in the Cisco ONS 15454 Troubleshooting Guide or the
Cisco ONS 15454 SDH Troubleshooting Guide.
Note If you set the port’s service state to OOS,DSBLD in Step 2, set the port’s service state back to
IS, and provision the GCC for that port according to the “DLP-G76 Provision GCC
Terminations” procedure on page 7-14.
Step 7 Return to your originating procedure (NTP).
DLP-G145 Enable or Disable OTN FEC Performance Monitoring
Step 1 In node view, double-click the card you want to monitor. The card view appears.
Step 2 Determine if the port where you want to enable or disable FEC is in service (IS). (Click the
Provisioning > Line tabs, and observe the Service State column for that port.) If it is IS, perform the
following tasks for that port. If not, go to Step 3.
a. DLP-G108 Change the Service State for a Port, page 7-18 to set the port to OOS,DSBLD.
b. DLP-G185 Delete a GCC Termination, page 10-40, if GCC is provisioned on that port.
Step 3 Click the Provisioning > OTN > OTN Lines tabs.
Step 4 Make an FEC selection based on the following rules:
• Choose Disable to disable the OTN FEC monitoring.
• Choose Enable to enable standard FEC monitoring for that port (default).
Step 5 Click Apply.
Step 6 Click the Performance tab to view PM parameters. For PM parameter definitions, refer to the
“Performance Monitoring” chapter in the Cisco ONS 15454 Troubleshooting Guide or the
Cisco ONS 15454 SDH Troubleshooting Guide.
Purpose This task enables or disables OTN FEC monitoring of node near-end or
far-end performance on a selected TXP_MR_10E or MXP_2.5G_10E
card and port during selected time intervals.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher