10-54
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G196 Log Out a User on Multiple Nodes
DLP-G196 Log Out a User on Multiple Nodes
Step 1 From the View menu, chose Go to Network View.
Step 2 Click the Provisioning > Security > Active Logins tabs.
Step 3 Choose the user that you want to log out.
Step 4 Click Logout.
Step 5 In the Logout User dialog box, check the nodes where you want to log out the user.
Step 6 Check Lockout before Logout if you want to lock the user out prior to logout. This prevents the user
from logging in after logout based on user lockout parameters provisioned in the Policy tab. A manual
unlock by a Superuser is required, or else the user is locked out for the amount of time specified in the
Lockout Duration field. See the “DLP-G189 Change Security Policy for Multiple Nodes” task on
page 10-47 for more information.
Step 7 In the Select Applicable Nodes area, uncheck any nodes where you do not want to change the user’s
settings (all network nodes are selected by default).
Step 8 Click OK.
Step 9 Click OK in the confirmation dialog box.
Step 10 Return to your originating procedure (NTP).
Purpose This task logs out a user from multiple nodes.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
