10-50
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G191 Change User Password and Security Level on a Single Node
Step 8 In the TCC CORBA (IIOP/SSLIOP) Listener Port area, choose a listener port option:
• Default - TCC Fixed—Uses Port 57790 to connect to ONS 15454s on the same side of the firewall
or if no firewall is used (default). This option can be used for access through a firewall if Port 57790
is open.
• Standard Constant—Uses Port 683 (IIOP) or Port 684 (SSLIOP), the CORBA default port number.
• Other Constant—If the default port is not used, type the IIOP or SSLIOP (Secure Socket Layer
Inter-ORB Protocol) port specified by your firewall administrator.
Step 9 In the SNMP Access area, set the Simple Network Management Protocol (SNMP) access state to
Non-Secure or Disabled (disables SNMP access).
Step 10 Click Apply.
Step 11 Return to your originating procedure (NTP).
DLP-G191 Change User Password and Security Level on a Single Node
Step 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 Click the user whose settings you want to modify, then click Edit.
Step 3 In the Change User dialog box, you can:
• Change a user password.
• Modify the user security level.
• Lock out the user.
See the “DLP-G54 Create a New User on a Single Node” procedure on page 3-6 for field descriptions.
Step 4 Click OK.
Step 5 Click OK in the confirmation dialog box.
Note User settings that you changed during this task will not appear until that user logs off and logs
back in.
Step 6 Return to your originating procedure (NTP).
Purpose This task changes settings for an existing user at one node.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
