1-75
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
DLP-G34 Install the AIC-I Card
DLP-G34 Install the AIC-I Card
Note When installing cards, allow each card to boot completely before installing the next card.
Step 1 Open the latches/ejectors on the card.
Step 2 Use the latches/ejectors to firmly slide the card along the guide rails in Slot 9 until the card plugs into
the receptacle at the back of the slot.
Step 3 Verify that the card is inserted correctly and close the latches/ejectors on the card.
Note It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
Step 4 Verify the following:
• The red FAIL LED turns on for 1 second, then blinks for up to 5 seconds.
• The PWR A and PWR B LEDs become red and the two INPUT/OUTPUT LEDs become green for
approximately 3 seconds.
• The PWR A LED turns green, the INPUT/OUTPUT LEDs turn off, and the ACT LED turns on.
Note It might take up to 3 minutes for the PWR A and PWR B LEDs to update.
Note If the red FAIL LED does not turn on, check the power.
Note If you insert a card into a slot provisioned for a different card, no LEDs turn on.
Note If the red FAIL LED is on continuously or the LEDs act erratically, the card is not installed
properly. Remove the card and repeat Steps 1 to 4.
Step 5 Return to your originating procedure (NTP).
Purpose This task installs the AIC-I card. The AIC-I card provides connections for
external alarms and controls (environmental alarms).
Tools/Equipment AIC-I card
Prerequisite Procedures DLP-G33 Install the TCC2 or TCC2P Card, page 1-72
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
