9-22
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G146 View Optics PM Parameters
Note If you set the port’s service state to OOS,DSBLD in Step 2, set the port’s service state back to
IS, and provision the GCC for that port according to the “DLP-G76 Provision GCC
Terminations” procedure on page 7-14.
Step 7 Return to your originating procedure (NTP).
DLP-G146 View Optics PM Parameters
Step 1 In node view, double-click the transponder or muxponder card where you want to view PM counts. The
card view appears.
Step 2 Click the Performance > Optics PM tabs (Figure 9-6).
Purpose This task enables you to view the optics PM counts on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E),
or muxponder (MXP_2.5G_10E, MXP_MR_2.5G, MXPP_MR_2.5G,
MXP_2.5G_10G) card and port to detect possible performance
problems.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
