Cisco ONS 15454 DWDM - G FC;FICON Payloads; Table 5-47 MXP_MR_2.5 G and MXPP_MR 2.5 G Card 1 G Ethernet or 1 G FC;FICON

5-77
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G321 Change the MXP_MR_2.5G or MXPP_MR_2.5G Card Line Thresholds for 1G Ethernet or 1G FC/FICON
DLP-G321 Change the MXP_MR_2.5G or MXPP_MR_2.5G Card Line Thresholds
for 1G Ethernet or 1G FC/FICON Payloads
Step 1 Display the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the line threshold
settings in card view.
Step 2 Click the Provisioning > Line Thresholds > RMON Thresholds tabs.
Step 3 Click Create. The Create Threshold dialog box appears.
Step 4 From the Port drop-down list, choose the applicable port.
Step 5 From the Variable drop-down list, choose an Ethernet variable. See Table 5-47 for a list of available
Ethernet thresholds.
Purpose This task changes the line threshold settings for MXP_MR_10G and
MXPP_MR_10E transponder cards carrying the 1G Ethernet or
1G FC/FICON payloads.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-47 MXP_MR_2.5G and MXPP_MR 2.5G Card 1G Ethernet or 1G FC/FICON
Variabl es
Variable Description
ifInOctets Number of bytes received since the last counter reset.
rxTotalPkts Total number of receive packets.
ifInDiscards Number of inbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
deliverable to a higher-layer protocol.
ifInErrors Total number of receive errors.
ifOutOctets The total number of octets transmitted out of the interface,
including framing characters.
txTotalPkts Total number of transmitted packets.
ifOutDiscards Number of outbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
transmitted.
mediaIndStatsRxFramesTruncated Total number of frames received that are less than 5 bytes.
This value is a part of high-level data link control (HDLC) and
GFP port statistics.
mediaIndStatsRxFramesTooLong Number of received frames that exceed the maximum
transmission unit (MTU). This value is part of HDLC and GFP
port statistics.
mediaIndStatsRxFramesBadCRC Number of receive data frames with payload cyclic
redundancy check (CRC) errors when HDLC framing is used.