Cisco ONS 15454 DWDM - Figure

9-32
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G152 View Payload SONET PM Parameters
Figure 9-13 SONET PM Tab on the Card View Performance Window
Step 3
Click Refresh. PM statistics appear for the selected port.
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Prev-n columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting Guide.
Note The MXP_MR_2.5G and MXPP_MR_2.5G cards support only the OC48/STM16 payload. Each
payload has a set of PM parameters.
Note To refresh, reset, or clear PM counts, see the “NTP-G73 Change the PM Display” procedure on
page 9-2.
Step 5 Return to your originating procedure (NTP).
115778
Performance tab
Card View
Payload PM tab
Direction
radio buttons
Help
button
SONET tab
Interval
radio buttons
Clear
button
Baseline
button
Auto-refresh
menu
Refresh
button
Port
menu