10-23
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G163 Modify a Static Route
Step 8 In the CTC Alerts dialog box, click Close. Wait for the reboot to finish. (This might take several
minutes.)
Step 9 Return to your originating procedure (NTP).
DLP-G163 Modify a Static Route
Step 1 In node view, click the Provisioning > Network tabs.
Step 2 Click the Static Routing tab.
Step 3 Click the static route you want to edit.
Step 4 Click Edit.
Step 5 In the Edit Selected Static Route dialog box, enter the following:
• Mask
• Next Hop
• Cost
See the “DLP-G58 Create a Static Route” task on page 3-18 for detailed field descriptions.
Step 6 Click OK.
Step 7 Return to your originating procedure (NTP).
Purpose This task modifies a static route on an ONS 15454.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
DLP-G58 Create a Static Route, page 3-18
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
