Cisco ONS 15454 DWDM - Figure 17-22 Passive Hybrid Terminal Example; Hybrid OADM Node

17-23
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 17 Node Reference
17.2.4 Hybrid OADM Node
Figure 17-22 Passive Hybrid Terminal Example
17.2.4 Hybrid OADM Node
A hybrid OADM node is a single ONS 15454 node equipped with at least one AD-xC-xx.x card or one
AD-xB-xx.x card, and two TCC2/TCC2P cards. The hybrid OADM node type is based on the DWDM
OADM node type described in the “17.1.3 OADM Node” section on page 17-4. TDM cards can be
installed in any available slot. Review the plan produced by MetroPlanner to determine slot availability.
Figure 17-23 shows an example of an amplified hybrid OADM node configuration. The hybrid OADM
node can also become passive by removing the amplifier cards.
OSC-CSM
Available
32MUX-O
32MUX-O
DCU
Air ramp
Available
TCC2/TCC2P
XC10G
XC10G
TCC2/TCC2P
AIC-I
96900
TXP, MXP or ITU-T line card
TXP, MXP or ITU-T line card
TXP, MXP or ITU-T line card
TXP, MXP or ITU-T line card
TXP, MXP or ITU-T line card
OSC-CSM, TXP, MXP or ITU-T line card