1-26
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
NTP-G5 Remove the Backplane Covers (ANSI Only)
NTP-G5 Remove the Backplane Covers (ANSI Only)
Step 1 Complete the “DLP-G13 Remove the Lower Backplane Cover” task on page 1-26.
Step 2 Complete the “DLP-G14 Remove the Backplane Sheet Metal Cover” task on page 1-27.
Step 3 Continue with the “NTP-G7 Install the Power and Ground” procedure on page 1-30.
Stop. You have completed this procedure.
DLP-G13 Remove the Lower Backplane Cover
Step 1 Unscrew the five retaining screws that hold the cover in place (Figure 1-11).
Purpose This procedure describes how to access the ONS 15454 ANSI backplane
by removing the covers. The backplane has two sheet metal covers (one
on either side) and a lower backplane cover at the bottom.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Prerequisite Procedures NTP-G2 Install the Shelf Assembly, page 1-8
NTP-G3 Open and Remove the Front Door, page 1-20
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
Purpose This task removes the lower backplane cover of the ONS 15454 ANSI shelf
assembly.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Prerequisite Procedures None
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
