Cisco ONS 15454 DWDM - Thresholds

5-79
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G307 Provision the MXP_MR_2.5G and MXPP_MR_2.5G Trunk Port Alarm and TCA Thresholds
DLP-G307 Provision the MXP_MR_2.5G and MXPP_MR_2.5G Trunk Port Alarm
and TCA Thresholds
Step 1 In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
trunk port alarm and TCA settings.
Step 2 Click the Provisioning > Optics Thresholds tabs.
Note You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Step 3 Provision the trunk port (Port 9) TCA thresholds for RX Power High to –9 dBm and for RX Power Low
to –23 dBm.
Step 4 Under Types, click the Alarm radio button and click Refresh.
Note Do not modify the Laser Bias parameters.
Step 5 Provision the trunk port (Port 9) Alarm thresholds for RX Power High to –7 dBm and for RX Power Low
to –26 dBm.
Note You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Step 6 Click Apply.
Step 7 Return to your originating procedure (NTP).
Purpose This task changes the MXP_MR_2.5G and MXPP_MR_2.5G trunk port
alarm and TCA thresholds.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher