Cisco ONS 15454 DWDM - Figure; Table 11-10 OPT-PRE and OPT-BST Optical Amplifier Line Settings

11-16
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G206 Change Optical Amplifier Line Settings for OPT-PRE and OPT-BST Amplifiers
DLP-G206 Change Optical Amplifier Line Settings for OPT-PRE and OPT-BST
Amplifiers
Step 1 In node view, double-click the OPT-PRE or OPT-BST amplifier where you want to change the optical
amplifier line settings.
Step 2 Click the Provisioning > Opt. Ampli. Line > Parameters tabs.
Step 3 Modify any of the settings described in Table 11-10. The provisionable parameters are listed in the
options column in the table.
Purpose This task changes the optical amplifier line settings for OPT-PRE and
OPT-BST amplifier cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 11-10 OPT-PRE and OPT-BST Optical Amplifier Line Settings
Parameter Description Options
Port # (Display only) Displays the port number. Displays port number and TX or RX.
Port Name Provides the ability to assign the specified port a
name.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the “DLP-G104 Assign a Name to a Port” task on
page 7-10.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, “DWDM Administrative and Service
States.”
From the drop-down list, choose one of the following:
• IS/Unlocked
• IS,AINS/Unlocked,automaticInService
• OOS,DSBLD/Locked,disabled
• OOS,MT/Locked,maintenance
Line Direction Provides the ability to associate a card with the line
direction. CTC automatically configures the line
direction during node setup. To change this setting,
you must change the Cisco MetroPlanner site plan
and import it to the node.
From the drop-down list, choose one of the following:
• East to West
• West to East
Service State (Display only) Identifies the autonomously
generated state that gives the overall condition of
the port. Service states appear in the format:
Primary State-Primary State Qualifier, Secondary
State. For more information about service states,
see Appendix C, “DWDM Administrative and
Service States.”
• IS-NR/Unlocked-enabled
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
• OOS-MA,DSBLD/Locked-enabled,disabled
• OOS-MA,MT/Locked-enabled,maintenance
Type (Display only) Identifies the type of port. Output Line