Cisco ONS 15454 DWDM - B.3.5 MIC-A;P FMEC Specifications (ETSI Only)

B-11
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
December 2006
Appendix B Hardware Specifications
B.3.5 MIC-A/P FMEC Specifications (ETSI only)
– Termination: 50-pin AMP champ connector
• Alarm outputs
– Number of outputs: 16
– Switched by opto MOS
– Triggered by definable alarm condition
– Maximum allowed open circuit voltage: 60 VDC
– Maximum allowed closed circuit current: 100 mA
– Termination: 50-pin AMP champ connector
• Environmental
– Overvoltage protection: as in ITU-T G.703 Annex B
– Operating temperature: –40 to +65 degrees Celsius (–40 to +149 degrees Fahrenheit)
– Operating humidity: 5 to 95 percent, noncondensing
– Power consumption: 3.00 W max., from +5 VDC from AIC-I, 10.2 BTU/hr max.
• Dimensions of AEP board
– Height: 20 mm (0.79 in.)
– Width: 330 mm (13.0 in.)
– Depth: 89 mm (3.5 in.)
– Weight: 0.18 kg (0.4 lb)
B.3.5 MIC-A/P FMEC Specifications (ETSI only)
The MIC-A/P FMEC card has the following specifications:
• Power supply input BATTERY B
– System supply voltage: Nominal –48 VDC
Tolerance limits: –40.5 to –57.0 VDC
– Connector: 3WK3 Combo-D power cable connector
• Alarm outputs
– Voltage (open contact): Maximum 60 VDC
– Current (closed contact): Maximum 250 mA
– Connector: 62-pin DB connector (common for inputs/outputs)
• Alarm inputs
– Voltage (open contact): Maximum 60 VDC
– Current (closed contact): Maximum 2 mA
– Connector: 62-pin DB connector (common for inputs/outputs)
• Environmental
– Operating temperature: –5 to +45 degrees Celsius (+23 to +113 degrees Fahrenheit)
– Operating humidity: 5 to 95 percent, noncondensing
– Power consumption: 0.13 W (provided by +5 V from the TCC2/TCC2P card), 0.44 BTU/hr