Cisco ONS 15454 DWDM User Manual

9-9
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G138 Refresh PM Counts for a Different Port
DLP-G138 Refresh PM Counts for a Different Port
Step 1 In node view (single-shelf mode), or shelf view (multishelf mode), double-click the DWDM, TXP, or
MXP card where you want to refresh PM counts for a different port. The card view appears.
Step 2 Click the Performance tab.
Step 3 In the Port drop-down list, choose a port.
Step 4 Click Refresh. The PM counts for the newly selected port appear.
Step 5 Return to your originating procedure (NTP).
NTP-G74 Monitor DWDM Card Performance
Step 1 Complete the “DLP-G46 Log into CTC” procedure on page 2-25 at the node that you want to monitor.
If you are already logged in, continue with Step 2.
Step 2 Complete the following tasks as needed:
• DLP-G139 View Optical Service Channel PM Parameters, page 9-10.
• DLP-G140 View Optical Amplifier Power Statistics, page 9-12.
• DLP-G141 View Optical Power Statistics for 32MUX-O, 32-WSS, 32-DMX-O, and 32DMX Cards,
page 9-13.
Purpose This task changes the window view to display PM counts for another
port on a TXP or MXP card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This procedure enables you to view, transmit, and receive performance
information for OSCM, OSC-CSM, 32MUX-O, 32DMX-O, 4MD,
AD-xC-xx.x, AD-xB-xx.x, 32WSS, OPT-BST, and OPT-PRE cards and
ports during selected time intervals to detect possible performance
problems.
Tools/Equipment None
Prerequisite Procedures Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see Chapter 7, “Create Channels
and Circuits” and Chapter 11, “Change DWDM Card Settings.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher

Cisco ONS 15454 DWDM Specifications

General

Chassis Type	DWDM
Form Factor	Rack-mountable
Slots	17
Storage Temperature	-40 to 158°F (-40 to 70°C)
Relative Humidity	5% to 95% non-condensing
Power Supply	AC or DC
Cooling	Internal fans
Operating Temperature	23 to 104°F (-5 to 40°C)
Altitude	0 to 6500 ft (0 to 1981 m)
Safety Compliance	EN 60950-1
EMI Compliance	FCC Part 15