10-40
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G184 Change a GCC Termination
DLP-G184 Change a GCC Termination
Step 1 Click the Provisioning > Comm Channels > GCC tabs.
Step 2 Click the GCC that you want to change.
Step 3 Click Edit.
Step 4 In the GCC Termination Editor dialog box, complete the following as necessary:
• GCC Rate—(Display only) Indicates the GCC rate.
• Disable OSPF on SDCC Link—If checked, Open Shortest Path First is disabled on the link. OSPF
should be disabled only when the slot and port connect to third-party equipment that does not
support OSPF.
• Far End is Foreign—Check this box to specify that the GCC termination is a non-ONS node.
• Far end IP—If you checked the Far End is Foreign check box, type the IP address of the far-end node
or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the far
end.
Step 5 Click OK.
Step 6 Return to your origination procedure (NTP).
DLP-G185 Delete a GCC Termination
Note Deleting the GCC termination on a port also deletes any provisionable patchcord links that might exist
on the port.
Step 1 Click the Provisioning > Comm Channel > GCC tabs.
Purpose This task modifies a GCC termination. You can enable or disable OSPF and
enable or disable the foreign node setting.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Remote
Security Level Provisioning or higher
Purpose This task deletes the DWDM GCC terminations required for network setup
when using the TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, and
MXP_2.5G_10G cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
