7-7
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 7 Create Channels and Circuits
DLP-G102 Filter the Display of Optical Channel Network Connections
DLP-G102 Filter the Display of Optical Channel Network Connections
Step 1 Navigate to the appropriate CTC view:
• To filter network circuits, choose View > Go to Network View.
• To filter circuits that originate, terminate, or pass through a specific node, choose View >
Go to Other Node, then choose the node you want to search and click OK.
• To filter circuits that originate, terminate, or pass through a specific card, double-click the card on
the shelf graphic in node view to open the card in card view.
Step 2 Click the Circuits tab.
Step 3 Set the attributes for filtering the circuit display:
a. Click the Filter button.
b. In the Circuit Filter dialog box, set the filter attributes by choosing one or more of the following:
• Name—Enter a complete or partial circuit name to filter circuits based on the circuit name;
otherwise leave the field blank.
• Direction—Choose one: Any (direction not used to filter circuits), 1-way (display only one-way
circuits), or 2-way (display only two-way circuits).
• OCHNC Dir—(DWDM OCHNCs only) Choose one: East to West (displays only east-to-west
circuits) or West to East (displays only west-to-east circuits).
• OCHNC Wlen—(DWDM OCHNCs only) Choose an OCHNC wavelength to filter the circuits.
For example, choosing 1530.33 will display channels provisioned on the 1530.33-nm
wavelength.
• Status—Choose one: Any (status not used to filter circuits) or Discovered (display only
discovered circuits). Other statuses do not apply to OCHNCs.
• State—Choose one: OOS (ANSI) or Locked (ETSI) to display only out-of-service circuits; IS
(ANSI) or Unlocked (ETSI) to display only in-service circuits (OCHNCs have IS/Unlocked
states only); or OOS-PARTIAL (ANSI) or Locked-partial (ETSI) to display only circuits
with cross-connects in mixed service states.
• Slot—Enter a slot number to filter circuits based on the source or destination slot; otherwise
leave the field blank.
• Port—Enter a port number to filter circuits based on the source or destination port; otherwise
leave the field blank.
• Type—Choose one: Any (type not used to filter circuits) or OCHNC (displays only OCHNCs).
Purpose This task filters the display of OCHNCs and circuits in the Circuits
window. You can filter the circuits in network, node, or card view based
on circuit or OCHNC name, size, type, direction, and other attributes.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
